Dish removal and transport
We take down the dish, bracket and LNB from your old address, wrap the LNB and coil the RG6 cable so nothing bends or cracks in transit. Cable ends are labelled so reconnection at the new property is quick and error-free.
Dish, decoder and cabling moved without losing your signal
DStv Relocation in Western Cape done right the first time
DStv Relocation in Western Cape means taking your dish, decoder, LNB and cabling from one property to the next and getting picture back on the same day. We handle houses, flats, estates and rentals from the Atlantic Seaboard to the Winelands. If you are moving this month, book the DStv move and reinstallation Western Cape homeowners rely on and skip the two-week wait for a signal that keeps dropping.
Careful work. Honest options.
About this service
What DStv Relocation in Western Cape actually involves
DStv Relocation in Western Cape is the removal, transport and re-commissioning of your existing satellite setup at a new address. It is not just unplugging a decoder. We strip the dish and wall brackets, label the RG6 coaxial cable runs, check the LNB for water ingress, then re-mount everything at the new property, re-aim the dish with a satellite signal meter and confirm your smart card and subscription still authenticate. Most single-decoder moves take two to three hours on site.
Western Cape moves come with their own quirks. Coastal salt air around Table View and Melkbosstrand eats F-connectors and cable clips within a season. Older Claremont and Rondebosch homes often have no existing dish mount, so we drill fresh masonry and seal it properly. Rentals in the City Bowl and V&A Waterfront usually need a landlord-friendly install that leaves no visible damage. That is why an affordable DStv move and reinstallation in Western Cape should always start with a site check, not a guess.
- ✓ Same-day signal restored
- ✓ No damaged dish or LNB
- ✓ Landlord and estate friendly
- ✓ Signal tested, not guessed
What's included
What is included in a DStv relocation
Every relocation we quote includes the removal, transport, re-installation and commissioning of your existing DStv equipment. Consumables like connectors, cable clips and silicone sealing are included. Replacement hardware, extra cable runs and new dish mounts are quoted upfront if we spot the need during the site check.
New mount and alignment
At the new address we mount the dish on a clear line of sight, drill and seal the wall, and aim with a satellite signal meter and compass and inclinometer until signal strength and quality are both locked in the green.
Cable and connector work
We re-run or extend RG6 coaxial cable as needed, crimp fresh F-connectors, fit cable clips and replace any section that is cracked or water-damaged. HDMI cable is checked where the decoder and TV are further apart than before.
Decoder reconnection and scan
Your decoder is reconnected, powered up and scanned for all channel groups. We confirm your smart card authenticates and check for common errors like E48-32 or E143-0 before we leave the property.
Signal test and warranty
You get a written signal reading, a short walkthrough of what changed, and a 90-day workmanship warranty covering the mount, cabling and alignment. If the signal drops in that window, we come back at no charge.
How it works
How our DStv relocation process runs
Call 066 443 8385 or send us the old and new addresses. We ask how many decoders, whether there is an existing dish at the new place, and what type of wall we are mounting to. You get a time slot and a fixed quote before we leave the yard. No call-out fee surprises.
At the old property we disconnect the decoder, remove the dish and wall bracket, and pull the RG6 coaxial cable where it is practical to do so. We label every cable end so reconnection at the new place is quick. LNB and dish condition get checked here, not later.
We mount the dish on a clear line of sight, run fresh RG6 where the old cable is too short or damaged, fit new F-connectors and cable clips, and earth the system where the property requires it. Drilling is sealed with silicone so no damp gets into the wall.
The dish is aligned with a satellite signal meter and compass and inclinometer until signal strength and quality are both in the green. We reconnect your decoder, run a channel scan and confirm your smart card reads correctly. If you have an Explora or a Pace unit, we check the HDMI handshake too.
We test every channel group, check for signal loss in bad weather by reading the margin, and clean up all offcuts and dust. You get a short walkthrough of what we changed and a 90-day warranty on the workmanship. Payment is on completion, card or EFT.
STEP 01Book and confirm
Call 066 443 8385 or send us the old and new addresses. We ask how many decoders, whether there is an existing dish at the new place, and what type of wall we are mounting to. You get a time slot and a fixed quote before we leave the yard. No call-out fee surprises.
Tools & methods
Tools and methods we use on every job
Satellite signal meter
Used to lock the dish onto the correct satellite and read signal strength and quality. Aiming by eye loses channels in rain; the meter gets it exact.
Compass and inclinometer
Sets the correct azimuth and elevation for the Western Cape before fine-tuning with the meter. Speeds up alignment and reduces trial and error on site.
Coaxial cable crimping tool and RG6 cable stripper
Produces clean, tight F-connectors on every cable end. Poorly crimped connectors are one of the most common causes of intermittent signal loss after a move.
Drill and masonry bits
For mounting dish brackets on brick, plaster and concrete walls. Every hole is sealed with silicone so damp cannot track into the wall.
Ladder and safety harness
Used for roof and high-wall dish work, including double-storey homes and estate properties where the dish sits above the first floor.
HDMI tester and multimeter
Checks the HDMI handshake between decoder and TV, and confirms power and continuity on the cable run before we call the job done.
Real results
Before and after.
DStv Relocation
Claremont flat to Rondebosch house
A single Explora decoder in a Claremont flat with a shared dish. The new Rondebosch house had no dish, no mount and no cable run, and the family was moving in over a weekend.
After: We fitted a new dish and bracket, ran 18 metres of RG6 to the lounge, crimped new F-connectors and had all channels live in under three hours. Signal strength read 82 percent with a healthy rain margin.
Book this service →
DStv Relocation
Coastal move in Table View
A three-year-old installation in Table View with corroded F-connectors and a cracked LNB cover. The client was moving two suburbs inland and wanted to reuse the existing dish.
After: We reused the dish, replaced the LNB and all four F-connectors, re-ran the cable with stainless clips and re-aimed with a signal meter. Signal quality went from 54 percent to 88 percent on the same dish.
Book this service →
DStv Relocation
Estate relocation in Kraaibosch
A family moving into Kraaibosch Country Estate with a dual-view setup. The estate restricted dish placement to one approved wall, and the existing cable run was too short for the new lounge layout.
After: We mounted on the approved wall, ran 25 metres of new RG6 to two rooms, fitted a splitter and installed both decoders. Both TVs tested clean, and the body corporate signed off without a follow-up visit.
Book this service → Problems we solve
Problems we solve on Western Cape relocations
Most relocation calls start with the same handful of issues. Here is what we see most often, why it matters, and how we fix it without a second appointment.
Ask a pro →Signal loss E48-32 after the move
We re-aim the dish with a satellite signal meter, check every F-connector for a tight fit, and test signal quality across the full channel range. The error clears on site and stays clear through rain.
Old LNB fails at the new address
We test the LNB before re-installing. If signal quality is weak or the unit shows water ingress, we fit a new SABS approved LNB on the spot and re-tune. No waiting for a parts order.
No existing dish or mount at the new property
We supply and fit a new dish, bracket and cabling, choosing a position that meets estate rules and gives clear line of sight. One appointment covers both the move and the fresh installation.
Cable too short or damaged in transit
We measure the new run, replace or extend the RG6 coaxial cable, crimp new F-connectors and clip the route neatly. Every cable is tested end to end before the decoder goes back on.
Proof you can check
Credentials and client feedback
- MultiChoice accredited installer · MultiChoice South Africa
- ICASA compliant installation · Independent Communications Authority of South Africa
- SABS approved equipment · South African Bureau of Standards
- PIRB registered · Plumbing Industry Registration Board
- Electrical compliance certificate (CoC) · Registered electrical contractor
Customer reviews
What clients say about our relocations
★★★★★
“We moved from a flat in Claremont to a house in Rondebosch and had no dish at the new place. The team arrived at 9, fitted a new bracket, ran fresh RG6 and had the Explora working by lunchtime. They sealed every hole and cleaned up. The quote I got on the phone was exactly what I paid.”
MV
Marlize V.Homeowner, Claremont
✓ Verified“
★★★★★
“Our estate has strict rules about where a dish can go. HDTEK knew the approved wall, mounted it there, and sorted the paperwork with the body corporate. Signal has not dropped once through the winter rain. Worth paying for a proper install rather than guessing.”
DP
Deon P.Estate resident, Kraaibosch Country Estate
✓ Verified★★★★★
“I was worried about losing my deposit over a dish on the balcony wall. They used a removable bracket, ran the cable neatly along the skirting, and left no marks. Landlord was happy, I had TV the same afternoon. Booked it on a Tuesday, done by Wednesday.”
AK
Aisha K.Tenant, V&A Waterfront
✓ VerifiedMost single-decoder relocations in the Western Cape run between R850 and R1,800 in 2026, depending on cable length, wall type and whether a new dish mount is needed. Multi-decoder or triple-view moves go higher. You get a fixed quote before we start, and the price includes labour, connectors and a signal test. Extra cable, a replacement LNB or a new dish is quoted separately if we find a fault on site.
You can physically carry the decoder and dish, but re-aiming a satellite dish without a signal meter is where most DIY moves fail. A dish that is two degrees off will still show some channels and then drop others the moment it rains. If you move it yourself, expect to book a technician for the alignment anyway. It is usually cheaper to have the whole relocation done in one visit.
We do, across the whole province. Our technicians cover the Atlantic Seaboard, Southern Suburbs, Northern Suburbs, Helderberg, Winelands and the West Coast. Call 066 443 8385 with your old and new addresses and we will confirm the nearest available slot. Same-day and next-day bookings are common outside peak month-end weekends.
A standard single-decoder move takes two to three hours on site, split between stripping the old installation and commissioning the new one. Multi-decoder or communal setups can take four to five hours. Travel between suburbs adds time, which is why we book a window rather than a fixed minute. You will have live channels before we pack up.
Where we deliver this service
Cities we serve for DStv Relocation
Our DStv relocation service Western Cape wide covers coastal towns, inland estates and dense city suburbs. Each area has its own installation quirks, from salt corrosion on the West Coast to estate placement rules in the Winelands. Here are some of the areas where we relocate DStv most often.
01
Arabella Country Estate
Estate-managed property near the Bot River lagoon. We follow Arabella's dish placement rules and use sealed connectors to handle the coastal moisture.
↗ 02 Benguela Cove Lagoon Wine EstateLagoon-side estate where salt air and wind affect dish mounts. We fit stainless fixings and re-aim with a signal meter for a stable picture.
↗ 03 Bluewater BayCoastal suburb where corroded F-connectors are common. We replace them with sealed fittings and test signal quality before leaving site.
↗ 04 Calypso BeachBeachfront properties need weather-resistant installs. We mount dishes on sheltered walls where possible and seal every drilled hole.
↗ 05 ClaremontOlder homes and flats with limited dish points. We drill fresh masonry, route cable neatly and work around period facades without visible trunking.
↗ 06 Da Gama ParkHillside suburb where line of sight can be blocked by trees and slopes. We survey for the clearest satellite window before mounting.
↗ 07 Delta Crest Equestrian EstateCountry estate with large plots and long cable runs. We plan the route to the main house and outbuildings so signal stays strong at every point.
↗ 08 Diemersfontein Country EstateWinelands estate with placement rules and long driveways. We confirm approved mounting positions and run cable without disturbing landscaping.
↗ 09 Fairview Agricultural EstateAgricultural estate where distances between buildings matter. We size the cable run correctly so the decoder gets full signal, not a weak feed.
↗ 10 Garden VillageCompact residential area with a mix of houses and flats. We handle single and dual-view relocations, including landlord-friendly installs for rentals.
↗ 11 HelderbergMountain-shadow area where dish placement is critical. We find the clearest satellite window and tune for a healthy rain margin.
↗ 12 Ida's ValleyTree-heavy valley suburb near Stellenbosch. We trim line-of-sight obstructions where allowed and aim carefully to avoid signal drop.
↗ 13 Kenrock Country EstateGated country estate with body corporate oversight. We mount on approved walls and provide documentation where the estate requires it.
↗ 14 Kraaibosch Country EstateEstate near George with strict placement rules. We handle the paperwork, mount on the approved wall and test both decoders on dual-view moves.
↗ 15 Laguna HillsResidential estate where coastal weather affects hardware. We use sealed connectors and stainless clips, and check the LNB for water ingress.
↗ Ready when you are
Book your DStv Relocation in Western Cape today
One call, one appointment, channels back the same day. MultiChoice accredited installers, fixed upfront pricing and a 90-day workmanship warranty. Call 066 443 8385 and tell us your old and new addresses.
Book My Relocation 066 443 8385 →
Request an appointment
Contact HDTEK
Call or WhatsApp 066 443 8385 and tell us the suburb, the error code and how many TVs you need. We answer seven days a week from 08:00, with 24/7 emergency call-outs for signal loss. Most Western Cape jobs are booked same-day or next-day, and you get a price before we dispatch a van.