Residential DStv Installation in Tamboerskloof
Most of our Tamboerskloof work is residential. The suburb is a mix of older family cottages, converted flats and small apartment blocks, and each type has its own install quirks. Family homes usually want dual view so the kids can watch in one room while the lounge stays on sport. Rentals need fast turnaround between tenants. Flats often share a communal dish, which changes how we diagnose a fault. Whatever the setup, we test the signal at the decoder before we pack up, and we leave the cable runs neat rather than stapled across a wall. If you are upgrading from an old Pace or Telefunken decoder to an Explora, we handle the swap and re-tune the dish in the same visit.
We mount and align a dish on your Tamboerskloof roof or gable, run RG6 coaxial cable to the decoder point and test the full signal chain. Most family homes here are done in two to three hours, including sealing every F-connector against winter damp.
Shared Tamboerskloof houses often need two or three viewing points off one dish. We fit a multi-switch, run separate cable runs and balance signal levels so no room drops out when another decoder is in use.
Upgrading from an older Pace or Telefunken unit to an Explora is a common Tamboerskloof request. We handle the swap, confirm the smart card is reading correctly and re-tune the dish so the new decoder gets the best signal available.
Tenants moving into a Tamboerskloof rental often need a dish installed or relocated quickly. We work to your move-in date, handle the removal at the old address and test the new setup before we leave.
- Signal tested at every decoder point before we leave, so you know it works before we pack up.
- Neat cable runs clipped and sealed, not stapled loosely across Tamboerskloof walls.
- Workmanship warranty on alignment and terminations, not just the hardware we fit.
