Residential DStv Installation in Norwood
Most of our Norwood work is residential. The suburb has a mix of older family homes, newer townhouses and rental flats, and each type has its own installation quirks. Older homes often need new cable runs because the existing wiring is past its best. Townhouses usually have a designated dish point that we work with. Rental flats need a clean, removable setup that the landlord will accept. Whatever the property, we aim to leave you with a tidy installation and a signal reading you can see.
We mount and align a new dish on your Norwood home, whether it is a freestanding house or a flat with a balcony mount. The technician sets the azimuth and elevation with a compass and inclinometer, then confirms with a signal meter before showing you the reading.
If your Norwood home has an older installation, the LNB and cable are usually the weak points. We test the LNB, replace it if needed, and run new RG6 coaxial cable where the existing run is damaged or too short for your TV position.
We diagnose decoder faults in Norwood homes, from freezing and restarts to smart card errors. If the unit is repairable we fix it on site. If not, we fit a compatible replacement and make sure it is authorised and scanning all channels before we leave.
For Norwood households with more than one TV, we install dual and triple view setups. That means extra RG6 runs, a MultiChoice-approved splitter and a tested outlet at each point. Popular in family homes where the lounge and bedrooms both need signal.
- One visit fixes most faults because we carry LNBs, cable and connectors on the van.
- You see the signal meter reading before and after, so you know the job is done properly.
- Neat cable routing with clips and wall plates keeps your Norwood home looking tidy.
