Residential DStv Installation in Dreyersdal
Most of our Dreyersdal work is residential, and the jobs range from a single decoder in a lounge to a full three-point setup across a family home and a flatlet. The houses here are a mix of older face-brick builds with pitched roofs and newer homes with flat-roof sections, so the mounting point and cable route change from property to property. Families in Dreyersdal usually want the same thing: a stable picture on every TV, no dropouts when the wind blows, and cabling that does not look like it was thrown up in an afternoon.
We mount the dish, aim it with a compass and inclinometer, run the RG6 coaxial cable to your decoder and meter the signal before we leave. Most Dreyersdal homes are done in a single visit, and we seal the wall entry so winter rain does not get into the cable.
For Dreyersdal homes with two or three TVs, we install a multiswitch and run dedicated RG6 runs from the LNB to each point. That means each decoder selects its own channel independently, with no drop in signal on the second or third TV when everyone is watching something different.
When your Dreyersdal picture starts breaking up or the decoder freezes, we test the LNB output and the decoder separately to find the actual fault. We replace the failing part with a compatible unit and re-check the full channel range, not just the one you were watching.
Moving within Dreyersdal or to a nearby suburb? We disconnect at the old address, transport the dish and decoder, re-mount and re-aim at the new place, and confirm the signal before we pack up. If the new property has a serviceable bracket, we re-use it and save you the cost of a new mount.
- Signal metered and tested before we leave, so you know it holds in bad weather.
- Cable clipped at 300mm intervals and sealed at every wall penetration.
- Upfront pricing on parts and labour, confirmed before anyone gets on the roof.
