Residential DStv Installation in West Bank
Most of our West Bank work is residential. Free-standing homes, townhouses and security estate units all need the same thing: a dish that stays aligned, cable that survives the weather, and a decoder that does not throw errors. Families here usually want a second view point for the kids' room or the back lounge, and they want the installation done without a mess. We plan the cable route before we drill, secure every run with cable clips, and test the signal at each point before we leave.
A standard installation for one TV in a West Bank home. We mount the dish, align it with a signal meter, run RG6 coaxial cable to the decoder and test the HDMI link to your TV. Most homes are done in two to three hours.
Second and third view points for West Bank families who want DStv in more than one room. We fit a multi-output LNB or multiswitch, run extra cable and set up each decoder independently. Every point gets its own signal test.
If your West Bank home has intermittent signal loss, the fault is usually outside. We test the LNB with a multimeter, inspect the cable run and replace failed connectors. Most repairs are done in under an hour.
A frozen or rebooting decoder in a West Bank home is often fixable, but sometimes it needs replacing. We carry Pace and Telefunken units and can swap a failed decoder on site, then re-pair the smart card before we leave.
- Signal tested with a meter at every point, so you know it will hold up in wind and rain.
- Cable routes planned before drilling, keeping holes and mess to a minimum.
- Common parts carried on the van, so most West Bank jobs finish in one visit.
