Residential DStv Installation in Pinehurst
Most of our Pinehurst work is residential, and the jobs vary as much as the houses do. Older freestanding homes often need a full re-cable because the existing run has been in the roof for a decade. Newer townhouses usually just need a clean dish mount and a tidy cable route that keeps the body corporate happy. Families with two or three TVs want Dual and Triple View installation so everyone can watch something different. Whatever the setup, we test the signal at each point before we leave, and we clean up after ourselves.
We mount and align a new dish on your Pinehurst home, run RG6 coaxial cable to the decoder and confirm the signal with a meter. Tile, face-brick and timber-frame walls all get the appropriate fixings and sealed entry points.
Adding a second or third decoder in a Pinehurst house means splitting the signal correctly. We fit a multiswitch, run separate cable to each room and balance the signal so no decoder starves the others.
Freezing, rebooting or smart card errors on Explora and Pace decoders are usually fixable on site. We test the power supply and signal input, repair where possible and quote a replacement only when the board is genuinely gone.
Moving house within Pinehurst? We strip your dish, decoder and cabling, transport it and reinstall at the new address with a fresh alignment. Old mounting holes get sealed and the new install is tested end to end.
- Upfront fixed quote before any work starts, so there are no surprise extras on the invoice.
- 12-month workmanship warranty on installations, covering alignment and connector faults.
- Same-day response for total signal loss, with Saturday slots available most weeks.
